Scatter and beam hardening effect corrections in pelvic region cone beam CT images using a convolutional neural network.
Authors
Affiliations (3)
Affiliations (3)
- Department of Applied Informatics, Graduate School of Science and Engineering, Hosei University, 3-7-2 Kajinocho, Koganei, Tokyo, 184-0002, Japan.
- Department of Radiological Technology, Faculty of Health Science, Juntendo University, 1-5-3 Yushima, Bunkyo-ku, Tokyo, 113-0034, Japan.
- Department of Applied Informatics, Faculty of Science and Engineering, Hosei University, 3-7-2 Kajinocho, Koganei, Tokyo, 184-0002, Japan. [email protected].
Abstract
The aim of this study is to remove scattered photons and beam hardening effect in cone beam CT (CBCT) images and make an image available for treatment planning. To remove scattered photons and beam hardening effect, a convolutional neural network (CNN) was used, and trained with distorted projection data including scattered photons and beam hardening effect and supervised projection data calculated with monochromatic X-rays. The number of training projection data was 17,280 with data augmentation and that of test projection data was 540. The performance of the CNN was investigated in terms of the number of photons in the projection data used in the training of the network. Projection data of pelvic CBCT images (32 cases) were calculated with a Monte Carlo simulation with six different count levels ranging from 0.5 to 3 million counts/pixel. For the evaluation of corrected images, the peak signal-to-noise ratio (PSNR), the structural similarity index measure (SSIM), and the sum of absolute difference (SAD) were used. The results of simulations showed that the CNN could effectively remove scattered photons and beam hardening effect, and the PSNR, the SSIM, and the SAD significantly improved. It was also found that the number of photons in the training projection data was important in correction accuracy. Furthermore, a CNN model trained with projection data with a sufficient number of photons could yield good performance even though a small number of photons were used in the input projection data.